Page 4 - Bell 315SK K Series

FEATURES AND OPTIONS
315
SK Engine
Meets EPA Tier 2 / EU Stage II emissions
John Deere Model 4045T - 4.5 litre, net
peak power (70 kW) turbocharged,
isolation mounted
Vertical spin-on engine oil filter
Vertical spin-on fuel filter with water
separator
2
micron Ultra Fine Diesel Filter
Oil-to-water engine oil cooler
Antifreeze, -37˚C
Coolant recovery tank
Serpentine belt with automatic belt
tensioner
Suction-type cooling fan
Enclosed safety fan guard
High ambient temperature engine cooling
Dual-element dry-type air cleaner
Muffler, under hood with curved-end
exhaust stack
Mechanical fuel lift pump
Powertrain
Powershift transmission: Torque converter
with Transmission Control Lever (TCL)
twist grip F-N-R, with neutral safety switch
interlock (1 through 4 gears)
5
th gear over-drive
Transmission oil cooler
Vertical spin-on transmission filter
Differential lock, electric foot-actuated
Planetary final drives
Power assisted hydraulic service brakes
(
conform to ISO 3450): Inboard, wet
multi-disc, self-adjusting and self
equalising
Parking/emergency brake with electric
switch control (conforms to ISO 3450):
Spring applied, hydraulically released wet
multi-disc / Independent of service brakes
Hydrostatic power steering with
emergency manual mode
Non-powered front axle
Mechanical-front-wheel-drive with traction
control limited-slip differential: Electric
on/off control / Driveshaft guard / Sealed
axle
Autoshift transmission
Backhoe
Standard dipperstick, 4.29 m digging
depth
Extendable dipperstick, 1.07 m extension
Heavy-duty backhoe bucket cylinder
Two-lever mechanical backhoe controls
Backhoe transport lock lever
Swing lock pin stored in operator’s station
Stabilisers with two-direction anti-drift
valves
Heavy-duty backhoe bucket
Auxiliary backhoe valve for hammers,
compactors with auxiliary plumbing
Loader
Loader bucket anti-spill (rollback)
Return-to-dig feature
Single-lever control with electric clutch
cut-off switch
Bucket-level indicator
Loader boom service lock
Ride control
Auxiliary loader hydraulics
Front loader hydraulic coupler for buckets,
forks, etc.
High-visibilty loader arms
Hydraulic System
136
L/min tandem gear pump,
open-centre system
Independent hydraulic reservoir
O”-ring face seal connectors
6-
micron vertical spin-on filter
Electrical System
12
volt system
90
amp alternator
Single battery with 190 min reserve
capacity and 950 CCA
Positive terminal battery cover
Blade-type multi-fused circuits
By-pass start safety cover on starter
Battery disconnect switch
Lights
Halogen work lights (6), 32 500
candlepower each (2 front, 2 rear, and
2
side docking)
Turn signal/flashing (2 front and 2 rear)
Rear stop and tail (2)
Rear reflectors (2)
Additional halogen work lights (4), 2 front
and 2 rear
Operator’s Station
Modular-design ROPS/FOPS level 2, cab
with molded roof (conforms to SAE
J1040): Isolation mounted
Left and right access
Slip-resistant steps and ergonomically
located handholds (conform to SAE J185)
Molded floor mats
Headliner
Coat hook
12
volt outlets - 2 in cab
Built-in beverage holders
Built-in Operator’s Manual storage
compartment
Interior rearview mirror
2
outside rearview mirrors
Rotary-dial hand throttle
Suspended foot throttle
Horn
Sealed switch module
Keyless start
Machine security (enabled through
monitor)
Engine coolant temperature guage,
illuminated electronic, with audible
warning
Oil temperature guage, illuminated
electronic, with audible warning
Fuel guage, illuminated electronic
Digital display of engine hours, engine
rpm, and system voltage
Monitor system with audible and visual
warnings: Engine air restriction / Low
alternator voltage / Engine oil pressure /
Hydraulic filter restriction / Parking brake
on/off / Seat belt / Low brake pressure /
Machine diagnostic information via
4-
pushbutton / LCD operator interface
Mechanical suspension deluxe fabric
swivel seat with lumbar adjustment and
armrests (fully adjustable)
Air suspension deluxe fabric swivel seat
with lumbar adjustment
Seat belt, 76 mm, with retractor
Cab: Headliner, dome light, left and right
cab doors, tinted safety glass, windshield
wiper (one rear and one front), front
windshield washer, fresh-air intake, heater
/
defroster / pressuriser (40,000 Btu/hr.
[11.7
kW] heater), and 12 volt outlets (2)
Air conditioner (26,000 Btu/hr. [7.6kW]
output and CFC-free R134a refrigerant)
Overall Vehicle
One-piece unitised construction
mainframe
Vehicle tie-downs (2 front and 2 rear)
Remote grease bank for front axle
204
kg front counterweight
Heavy duty front bumper
Rubber grille bumpers
Fuel tank, 155 L, ground-level fueling
Two-position easy tilt hood
Extended grille frame
Removable toolbox with padlock latch
Vandal protection for locking, engine
hood, toolbox, hydraulic reservoir, and fuel
tank
Reverse warning alarm
Sound reduction package
Dent-resistant full-coverage rear fenders
Standard Equipment
Optional Equipment
All dimensions are shown in millimetres, unless otherwise stated between brackets. Under our policy
of continuous improvement, we reserve the right to change specifications and design without prior
notice. Photographs featured in this brochure may include optional equipment.
SPEC/1188/06/12 - K-series 315SK Spec
Tel: +7 495 647 2090